Read Barcodes With Gps Coordinates (Kdc250G/350G) - KoamTac KDC20 User Manual

KDC User
YOUR
If scanning was unsuccessful, the user will hear two short beeps, the LEDs will
illuminate red, and the message
should point the KDC at the barcode and press the scan button while trying the
following suggestions:
Modify the angle of the KDC in relation to the barcode, making the angle more

wide or narrow as needed. (Laser Model)
Modify the distance between the barcode and the KDC, moving closer or

further away as needed.
Check the option settings defined in the KDC menu section and change

options as needed.
Check to see that the barcode's width does not exceed the light beam's width,

and vice versa.

Read Barcodes with GPS Coordinates (KDC250G/350G)

The KDC350G may add GPS coordinates after the barcode data. To do so, the user
may follow the below instructions.
Because of the characteristics of GPS, this function is only available when
Note
outdoors.
1.
Go to GPS Power in GPS Menu and select Enable.
2.
Check to see if the KDC is successfully acquiring GPS data by selecting
Acquire Test in GPS Menu.
When the user selects the Acquire Test, an
the screen. If this is the first test, check to make sure the 'Acquired' message
appears within 90 seconds of acquiring GPS signal.
3.
Go to SystemConfig in the KDC Menu and select GPS data in Display Format.
4.
After finishing the configuration, scan a barcode as explained in 3.2.1 Reading
Barcodes.
When the user has successfully scanned a barcode, the barcode data and GPS
coordinate will appear on the KDC screen.
For more information, refer to 3.3 Menu - GPS Config (KDC250G/350G).
KDC
Failed reading
will display. If this is the case, the user
'Acquiring'
message will appear on
49