Current Kdc Wedge Method - KoamTac KDC20 User Manual

KDC User Manual
If this option is selected, the stored barcode data is cleared from the KDC memory after
synchronization.
It is important to clear the KDC memory periodically to prevent a Buffer Full

message. Buffer Full prevents the KDC from storing additional data. Stored
barcode data may also be deleted using the Reset Memory feature on the KDC.
Automatically Synchronize after Connection
This option lets the user automatically synchronize collected data immediately to the
computer when the KDC is connected to the host.
IMPORTANT: Before selecting this option, remember to configure all options

properly.
Data synchronization may be done manually by clicking the synchronize icon if

this option is not selected.
Beep while Synchronization
The user may enable or disable the beep tone during the synchronization process. If
this option is selected, a beep is sounded every time barcode data is synchronized.
The KDC beeps 5 times when the synchronization process is complete.
Append Data to File
If the user has specified a file name and Append data to File option is enabled, KTSync
will append data to the existing file instead of creating a new file.

Current KDC Wedge Method

The KDC may be configured in one of five wedge/store modes:
Wedge Only - Scanned data is transmitted to the host. The KDC does not store

scanned data.
Wedge & Store - Scanned data is stored in the KDC and transmitted to the

host.
Store Only - Scanned data is stored in the KDC but NOT transmitted to the

host.
Save if Sent - Scanned data is stored in the KDC ONLY if transmission to the

host is successful.
Save if Not Sent - Scanned data is stored in the KDC ONLY if transmission to

the host is unsuccessful.
S
YNCHRONIZATION
128