Auto Connect; Auto Reconnect; Auto Power On; Pwr On Time - KoamTac KDC Series User Manual

KDC User Manual

Auto Connect

This feature enables the KDC to automatically connect to the host device when the KDC is
powered on.
IMPORTANT: Until the host device and the KDC have been fully tested, it is strongly
recommended that this feature be set to 'Disable', because a host device that does not
support this feature could cause problems, such as power loss or upload delays.
The KDC automatically tries to connect to the host 10 times within the
Note
duration of two minutes when
disconnected, Auto Connect is enabled, and system Sleep Timeout is set to 5
seconds.

Auto Reconnect

This feature enables the KDC to automatically connect to the host device when the KDC is
disconnected from a host.
IMPORTANT: This feature is available when KDC Connect Device options are MFi, HID iOS,
or HID Normal.
The KDC tries to connect automatically to the host 10 times within the duration
Note
of two minutes if Bluetooth is disconnected.

Auto Power On

The Auto Power On option Enables the KDC to automatically power on Bluetooth when the
SCAN button is pressed. The default setting is Disabled.
Users should press the scan button for the duration defined in the BT Config
Note
Power-on time option. The host program may have to open the COM port again
in order to be reconnected with the KDC.

PWR ON Time

The PWR On Time option works in conjunction with the Auto Power On option. The default
value is Disabled. If the KDC Bluetooth power is off, you may turn on the Bluetooth power
by pressing the SCAN button for the PWR On Time option value.
Bluetooth
power is ON,
B
LUETOOTH
Bluetooth
is
74