Auto Connect - KoamTac KDC20 User Manual

4.1.2 Auto Connect

This feature allows the KDC to connect automatically to the host device when the KDC is
powered on.
IMPORTANT: Until the host device and KDC have been fully tested, it is strongly
recommended that this feature be set to Disable because a host device that does not
support this feature can cause problems such as power loss or upload delays.
[Note] KDC automatically tries to connect to the host 10 times during two minutes when
Bluetooth
power is ON,
Sleep Timeout is set to 5 seconds
4.1.3 Auto Reconnect
This feature allows the KDC to connect automatically to the host device when the KDC is
disconnected from a host.
IMPORTANT: This feature is available when KDC "Connect Device" options are
"iPhone","HID iOS" and "HID Normal ".
Note:

KDC tries to connect automatically to the host 10 times during two minutes if
Bluetooth
4.1.4 Auto Power On
The Auto Power On option allows the KDC to automatically power on Bluetooth when
the SCAN button is depressed. The default setting is Disabled.
NOTE: The host may have to open the COM port before reconnecting with the KDC.
Power-on time determines the scan button pressing time to activate Auto Power On
feature.
4.1.5 PWR ON Time
The PWR On Time option works in conjunction with the Auto Power On option. Default
value is Disabled. If KDC Bluetooth power is off, user can turn on Bluetooth power by
pressing SCAN button for PWR On Time option value.
Bluetooth
is disconnected, Auto Connect is enabled and system
is disconnected.
49
KDC User Manual
Revision 3.05.R6
Copyright ® 2014, KoamTac, Inc.