Discovering - KoamTac KDC20 User Manual

KDC User Manual
Bluetooth connection has been established.
For KDC500 paring with the host, Numeric Comparions pairing method is required for
PCI PTS complicance. See the section

Discovering

KDC200/250/270/300/350 starts to search for neighboring
Discovering menu is executed. It will take about 30 seconds to finish searching and to
list available neighboring
corresponding Bluetooth MAC address in the KTSync Bluetooth menu, instead of
waiting for the KDC to search for neighborhood
only supports via KTSync configuration. KDC500 doesn't support this feature.
Connect To
This option lets you easily connect the KDC to
previously registered in KTSync under the File Menu or discovered/connected from the
Bluetooth
KDC
configuration. KDC500 doesn't support this feature.
There could be an interoperability issue depending on the corresponding
Note
device Bluetooth stack. The master Bluetooth device may request that you
to follow the master Bluetooth device's security procedures, if the KDC tries
to connect to the master Bluetooth device.
HID Sync
The user may synchronize stored barcode data over HID using the HID Sync option.
The KDC will start to transmit all stored barcode data upon execution of the HID Sync
option. KDC500 doesn't support this feature.
Tips
Pair and connect KDC20i/30i/200i/250i/270i/300i/350i/400i/470i and iOS4.0+ in HID iOS
mode
 Users have to disable the MFi option in System > MFi menu and change
Note
the Bluetooth profile to HID-iOS to use HID Bluetooth profiles
Bluetooth
Service menu. KDC20/30/400/470 only supports via KTSync
2.1 Bluetooth Paring
devices. Another option is to enter the
Bluetooth
Bluetooth
B
LUETOOTH
for the details.
Bluetooth
devices if the
devices. KDC20/30/400/470
devices that have been either
.
117