Pitney Bowes 2030 Manual page 94

Use the left (t t ) or right (u u ) arrow keys to adjust the
9.
volume, then press YES.
10. Press YES to select Document Separator (or t t to
move to the next item). Press YES again.
11. Press 2 to print an Index Mark on the first page of a
fax reception, then press YES.
Note: If equipped with an optional cassette(s), you
can also select to have a Separator Page inserted
between receptions.
12. Press YES to adjust the Power Saver feature
move to the next item). Press YES.
The default setting for Power Saver mode is 2=ON.
This means that the unit will automatically turn the
heating element ON only when a print operation is
imminent. If you select 1=OFF, the heating element
will remain on all day, every day.
3=MON-FRI, the heating element will be ON, 8 am to 5
pm Monday through Friday, unless you contact the
Diagnostic Center to remotely program custom
settings.
13. Press the desired Power Saver setting, 1, 2 or 3, then
press YES.
14. Press YES to select Power Saver Timer or proceed to
Step 15. This setting determines how long the unit
must be idle before going into "Sleep Mode."
15. Press the NO key to erase the current setting. Enter
the desired setting, e.g., 1, using the numeric keypad.
Press YES.
16. Press STOP to return to System Ready mode.
If you wish to print a System Set Up Report, showing
the revised settings, press the REPORTS key. Press
arrow key (q q ) until SYSTEM SET UP
the down
REPORT appears in the display. Press YES.
DOCUMENT SEPARATOR?
PRESS YES, NO OR t t s s
1=OFF
(
or t t to
PRESS YES, NO OR ts
1=OFF 2=ON 3=MON-FRI
If you select
POWER SAVER TIMER ?
PRESS YES, NO OR ts
PRESS YES, NO OR t t s s
89
PRINT INDEX MARK ?
PRESS YES OR NO
PRINT INDEX MARK
2=ON
POWER SAVER?
POWER SAVER
POWER SAVER TIMER
5minutes (1-255)
MACHINE ID SETTING ?
JAN 10 2001 10:00
SYSTEM READY