Pitney Bowes 2030 Manual page 55

AutoDial Job (up to 30). See Section 5.3.2, "Polling with Programmable AutoDial
Jobs" for the procedures to poll using this method.
To create a list for sequential polling:
Do This
1. With no documents inserted in the Model 2030
Automatic Document Feeder, press the appropriate
One- Touch key(s) that contain the group or list to
poll. Example: One-Touch keys #01, #02, #06, #10,
#22...
2. Press SEND/RECEIVE.
3. Press YES.
4. Enter the Passcode, if required by the fax unit you
are polling, then press YES or press NO if a
Passcode is not required.
NOTES:
1. All remote fax units on the created list to be polled must have the same
Passcodes or require no Passcode at all.
2. If one of the dialed numbers in the Sequential Polling List is busy or does not
answer, that number will move to the "bottom" of the polling list. And the next
number on the list will be dialed. The busy or "no answer" numbers will be
retried until the "retry count" is exhausted.
3. To use an AutoDial Job or a P-Key to poll after hours, see Section 5.3.2,
"Polling with Programmable AutoDial Jobs" for the procedures to poll using
these methods.
4. If you attempt to poll with pages loaded in the feeder, the machine will switch
into the Send Mode. Pages should only be loaded in the feeder if you intend
to Turnaround Poll or Send. Refer to Section 4.6.6, "Turnaround Polling" for
instructions on performing this Function.
5. There is no universal polling standard. It may not be possible for your Model
2030 to poll certain non-Pitney Bowes machines.
This Happens
After each One-Touch key is
pressed, the associated num-
ber and name will appear in the
display.
50
DO YOU WISH TO POLL?
ENTER PASSCODE
IF NEEDED _ _ _ _