Pitney Bowes 2030 Manual page 68

5.3 Programmable AutoDial Jobs
The single transmission procedures described earlier in Section 4.4 are only a
small part of the Model 2030 transmission capabilities.
transmission power is from the programmable AutoDial Jobs. Programmable
AutoDial Jobs are entered through the AutoDial Feature.
You can program up to 30 AutoDial Jobs using the AutoDial Feature on the
Model 2030. Since all pages associated with an AutoDial Job are sent to
memory, remember that your Model 2030 can store approximately 60 pages,
with standard memory.
A programmable AutoDial Job is a transmission instruction you enter from the
Operator Control Panel.
AutoDial Jobs include:
• Sending a document after hours to multiple destinations
• Polling after hours (simple, sequential, etc.)
• Serial broadcasting (sending to multiple locations)
• Sending to a Relay Station
• Sending to a private Mailbox
• Instructing the remote machine to print multiple copies
• Turnaround polling
You can program the following selections from the AutoDial Feature Menu:
• 1=SND  Sending
• 2=RCV  Receiving or polling
• 3=RELAY  For Relaying
• 4=SND/RCV  Turnaround Polling
• 5=MAILBOX  To send to Mailboxes of a remote machine
• 6=POLL  Allows other machines to call and receive documents in your
unit's memory
The Model 2030 really provides two types of Delayed communications Jobs, the
AutoDial Jobs (reviewed in this Section) and those stored in Programmable One-
Touch keys (P-Keys are reviewed in Section 5.5). The difference between these
two types of Delayed Job Communications features is as follows:
• With a programmable AutoDial Job, once it has been completed it does not
exist in memory any longer.
• With a programmable One-Touch key (P-Key), you can store a Delayed (or
immediate) Communication Job permanently. The Job programmed in the
P-Key will be repeated every time you press that P-Key. If you call the
same location on a regular basis, you may want to store the Jobs
permanently in a One-Touch Program Key.
dedicated programmable One-Touch keys (P1, P2, P3, P4, P5). Refer to
Section 5.5 for information on Program Keys.
Examples of when you would use programmable
63
The additional
The Model 2030 has 5