Pitney Bowes 2030 Manual page 126

To enter a Dual Node Relay programmable AutoDial job:
Do This
1. Insert the document face down in the Document
Feeder and press FEATURES twice.
2. Press YES.
3. Press 3, and then press YES.
4. Press YES for Dual Node Relay. The 2030 cannot
be used as a Relay Station.
5. Enter the NODE 1 Speed Dial number or One Touch
Key followed by YES.
6. If you entered a Speed Dial number, press YES a
second time.
7. Press YES and enter another number by one of the
methods mentioned in Step #5 above. Repeat Steps
#5 and #6 until all numbers are entered. Then press
NO to continue.
8. Enter the NODE 2 Speed Dial number or One Touch
Key followed by YES. The Speed Dial numbers or
the One Touch Key numbers you select must
already be stored as Relay Stations or the display
will read "#XXX not a Relay Station". Remember:
the 2030 cannot be used as a Relay Station.
9. If you entered a Speed Dial number, press YES a
second time.
10. Press YES and enter another number by one of the
methods mentioned in Step #8 above. Repeat Steps
#8 and #9 until all numbers are entered. Then press
NO to continue.
11. Enter the number corresponding to the correct
Mode and then press YES. Or, just press YES for
Normal Mode.
This Happens
ENTER NODE 1 STATION #
The number appears in the
display.
ENTER NODE 2 STATION #
The number appears in the
display.
1:NORMAL
3:EXTRA FINE
121
AUTO DIAL?
PRESS YES, NO OR t t s s
1:SND 2:RCV 3:RELAY
4:SND/RCV 5:MAILBOX
DUAL NODE RELAY?
PRESS YES OR NO
ANOTHER NUMBER?
ANOTHER NUMBER?
2:FINE
4:U-FINE
ENTER FINAL DEST.#