Pitney Bowes 2030 Manual page 16

1) Display Area
The two-line display has space for up to 20 characters per line. Messages
that appear in the display confirm the date and time, or the current operation.
When POWER is on, the display will indicate the system status. If the display
is blank, check power switch and power plug.
If δ δ or χ χ are shown in the display. Pressing the δ δ or χ χ key will shift back and
forth between the previous and next screens.
2) On Line Light
Indicates that communications are occurring. The display will remain in the
"System Ready" mode (see Communication Status key).
3) Out of Toner Light
The OUT OF TONER indicator will illuminate when low or out of toner.
4) Reports Key
Press the REPORTS key* to print the following reports, directories and forms:
•
Journal Report (view and/or print)
•
Jobs Report
•
Speed Dial Directory
•
One-Touch Directory
•
P-Key Directory
•
System Set Up Directory
•
(Toner) Cartridge Order Form
•
One-Touch Sheet (control panel overlay)
*Also used as the left CURSOR ( β ) key.
5) Communication Status Key
a. The display can be switched by pressing and releasing the
COMMUNICATION STATUS key* once for the Transmission Speed,
Remote ID or twice for Job # and Page #, to allow for monitoring of the
transmission in progress (on line).
received while copying is in progress, the state of reception can be
verified. The display will revert to "System Ready" after 5 seconds.
b. The COMMUNICATION STATUS key and then the STOP key can be
pressed in order to cancel a transmission from memory.
c. After pressing the VOICE key, press the COMMUNICATION STATUS
key to lower or increase the volume of the Monitor (Speaker).
*Also used as the right CURSOR ( α ) Key.
Even if the document is being
11