Pitney Bowes 2030 Manual page 124

To enter a Single Node Relay programmable AutoDial job:
Do This
1. Insert the document face down in the Document
Feeder and press FEATURES twice.
2. Press YES.
3. Press 3, and then press YES.
4. Press NO for Single Node Relay.
5. Enter the Relay Station Speed Dial number or One-
Touch Key followed by the YES.
6. If you entered a Speed Dial number, press YES a
second time.
7. Press YES and enter another number by one of the
methods mentioned in Step #5 above. Repeat Steps
#5 and #6 until all numbers are entered correct. Then
press NO to continue.
8. Enter the number corresponding to the correct Mode
and then press YES. Or, just press YES for Normal
Mode.
9. Enter the Speed Dial number or One Touch number
to which the Relay Station should send the
document.
Touch numbers you select must already be stored in
the Relaying fax unit.
locations here. If the destinations are stored as One
Touch Keys, just keep pressing the appropriate Keys
until you have specified all destinations. However,
you must press YES after each new Speed Dial
number. Press NO when you finish
numbers.
The Speed Dial numbers or the One
You can specify many
This Happens
The appropriate Speed Dial or
One Touch Key number and
name appears in the ddisplay.
entering all
119
AUTO DIAL?
PRESS YES, NO OR t t s s
1:SND 2:RCV 3:RELAY
4:SND/RCV 5:MAILBOX
DUAL NODE RELAY?
PRESS YES OR NO
ENTER RELAY STATION#
ANOTHER NUMBER?
1:NORMAL 2:FINE
3:EXTRA FINE 4:U-FINE
ENTER FINAL DEST. #
ANOTHER NUMBER?
ENTER YES OR NO
ENTER TIME
_ _ : _ _