Pitney Bowes 2030 Manual page 73

5.3.4 Sending and Receiving with Programmable AutoDial Jobs
To send and receive with a Programmable AutoDial Job (Turnaround Polling):
Do This
1. If you need to set a polling Passcode, refer to
Section 5.7.7 for instructions.
2. Load pages you wish to send into the Document
Feeder face down, then press FEATURES twice.
3. Press YES.
4. Press 4, then press YES.
5. Enter one of the following: a phone number from
the Numeric Keypad; a Speed Dial number; or a
One-Touch key.
6. Press YES after entering the number (if you entered
a Speed Dial number, press YES a second time).
7. Press YES to enter another number by one of the
methods mentioned in Step #5 above.
Steps #5-#7 until all numbers are entered.
press NO to continue.
NOTE: Up to 32 random numbers can be entered
from the Numerical Keypad.
8. Enter the number corresponding to the correct
resolution mode and then press YES. Or just press
YES for NORMAL.
9. If the remote location requires a Passcode, enter the
correct four-digit Passcode, then press YES. Press
NO if a Passcode is not required.
This Happens
The number will appear in the
display.
Repeat
Then
68
AUTO DIAL ?
PRESS YES, NO,
1=SND, 2=RCV, 3=RELAY
4=SND/RCV, 5=MAILBOX
ENTER DESTINATION#
z
ANOTHER NUMBER?
ENTER YES OR NO
1=NORMAL 2=FINE
3=EXTRA FINE 4=U-FINE
ENTER PASSCODE
IF NEEDED _ _ _ _
ENTER TIME
__ __:__ __
ts