Command Trigger Mode - Newland NLS-HR1550-30 User Manual

**【Enter Setup】

Command Trigger Mode

Command Trigger Mode: The scanner activates a decode session when receiving the command string of
"$$$$#99900035;%%%%" or scanning the Start Trigger Simulation barcode. The decode session continues until the
barcode is decoded, or the scanner receives the command string of "$$$$#99900036;%%%%" or scans the Stop Trigger
Simulation barcode.
If the scanner receives the command string of "$$$$#99900036;%%%%" or scans the Stop Trigger Simulation barcode
during a decode session, it will stop the decode session and send a 2-character message (e.g., 0A or 0X ) to the host
device to indicate decoding failure.
【Command Trigger Mode】
【Start Trigger Simulation】
【Stop Trigger Simulation】
You can define a no read message to be sent to the host device when the scanner in the Command Trigger mode fails to
decode a barcode.
【Define a No Read Message】
【Exit Setup】
33