Newland NLS-HR1550-30 User Manual page 37

Decode Session Timeout: This parameter sets the maximum time decode session continues during a scan attempt. The
default timeout is 15s.
To program this parameter, scan the Decode Session Timeout barcode and the numeric barcodes. To find the numeric
barcodes, see the "Digit Barcodes" section in Appendix.
Note: Decode Session Timeout: 01-15, corresponding to 1s, 2s, ......, 15s (default), in 1s increments; 00: infinite.
You can also configure whether to allow rereading same barcode. By default, rereading same barcode is not allowed.
【Decode Session Timeout】
【Allow Rereading Same Barcode】

Allow Rereading Same Barcode
This allows the scanner to reread the same barcode that has been decoded in the previous session.

Disallow Rereading Same Barcode
This protects against accidental rereads of the same barcode. If the barcode being scanned is identical with the one
previously scanned, the decode session will suspend until a different barcode comes up.

Recalculate Timeout After Good Read
The decode session timeout restarts after a good read.
25
**【Disallow Rereading Same Barcode】
【Recalculate Timeout After Good Read】
**【Enter Setup】
【Exit Setup】