General Programming
General Programming
Reading Mode
Command Triggered Mode
After programming, when FM100 receives trigger sweep command from
terminal(e.g. PC)or read "Start Analog Trigger" barcode, the scanner will start to
work.
PS: If reading is successful, data will be returned and the scanner wil stop working
automatically. Or the scanner will keep reading until receiving stop command or
reading "Stop Analog Trigger".
When FM100 receives stop command from terminal (e.g. PC)or read "Stop Ana-
log Trigger" barcode, the scanner will stop. Meanwhile a 2 byte data(e.g. 0A;0X)
must be returned.
Start Analog Trigger
【Pro CMD:99900035】
If a reading is failed, the scanner will send a character which means a reading failure. Users could set the
character themselves.
nlscan.com
Command Triggered Mode
【Pro CMD:99900116】
Set Reading Failure Character
【Pro CMD:99904200】
Code Programming ON
Code Programming OFF
Stop Analog Trigger
【Pro CMD:99900036】
Tools
Page 20