Programming Barcode/ Programming Command/Function - Newland NLS-HR1550-30 User Manual

Programming Barcode/ Programming Command/Function

4
The figure above is an example that shows you the programming barcode and command for the Enter Setup function:
1. The Enter Setup barcode.
2. The Enter Setup command.
3. The function that can be enabled by using the programming barcode or command listed above.
4. ** indicates factory default settings.
Use of Programming Barcodes
Scanning the Enter Setup barcode can enable the scanner to enter the setup mode. Then you can scan a number of
programming barcodes to configure your scanner.
The HR15 corded scanner is in the setup mode by default. In real application, programming barcodes hardly overlap with
non-programming barcodes, so it is unnecessary to exit the setup mode each time you finish the configuration.
Some functions or options may involve parameter value settings that require scanning numeric barcodes. To find the
numeric barcodes, see the "Digit Barcodes" section in Appendix.
The scanner can be configured to send or not to send programming barcode data (i.e. programming command) to the host
device by scanning the appropriate barcode below. By default, the Do Not Send the Programming Barcode Data option
is enabled. Note that restarting/rebooting the scanner will reset this parameter to its default value.
【Send the Programming Barcode Data】
17
**【Do Not Send the Programming Barcode Data】
**【Enter Setup】
1
2
3
【Exit Setup】