Command Trigger Mode
Command Trigger Mode: Decode session is activated by a host command. The decode session
continues until the barcode is decoded or the decode session timeout expires.
Decode Session Timeout: This parameter sets the maximum time decode session continues during a
scan attempt. It is programmable in 1s increments from 1s to 255s. The default timeout is 15s. If the
parameter is set to 0, the decode session timeout is infinite.
Example: Set the decode session timeout to 5s
1.
Scan the Enter Setup barcode.
2.
Scan the Decode Session Timeout barcode.
Scan the numeric barcode "5". (See the Digit Barcodes section in Appendix)
3.
4.
Scan the Save barcode. (See the Save/Cancel Barcodes section in Appendix)
5.
Scan the Exit Setup barcode.
49
Command Trigger Mode
Decode Session Timeout
** Enter Setup
Exit Setup