Scan Mode - Newland NLS-HR1550-30 User Manual

Scan Mode

Manual Mode
Manual Mode (default): A trigger pull activates a decode session. The decode session continues until the barcode is
decoded or you release the trigger or the decode session timeout expires (default: 15 seconds; programmable).
Decode Session Timeout: This parameter sets the maximum time decode session continues during a scan attempt. The
default timeout is 15s.
To program this parameter, scan the Decode Session Timeout barcode and the numeric barcodes. To find the numeric
barcodes, see the "Digit Barcodes" section in Appendix.
Note: Decode Session Timeout: 01-15, corresponding to 1s, 2s, ......, 15s (default), in 1s increments; 00: infinite.
23
**【Manual Mode】
【Decode Session Timeout】
**【Enter Setup】
【Exit Setup】