Table of Contents
Advertisement
【Start Setup】
The scanner can set the time interval of scanning in the continuous reading mode.
Note：In the continuous reading mode, the time interval of scanning is in unit of 500ms, the parameter ranges from 0 to
7500ms
Extended Sense Reading Mode
The device will to check the environmental change in front of the scanning window. It will delay 200ms before the scanner
begin to read. After reading the barcode, the scanner will stop and stay in the checking mode, waitng for the next
environment change.
In the extended sense reading mode, the scanner can set the barcode reading time and the time intervals.
【Set the Barcode Reading Time】
In the extended sense reading mode, the barcode reading time takes 2sec as the unit, the parameter range is 0-30sec, 0
means non-stop.The time interval takes 200ms as the unit, the parameter ranges from 0 to 300ms.
Command Triggered Reading Mode
After setup, to begin triggered scanning by sending the stop command in the terminal (such as PC) or reading the ―Begin
Simulating Trigger‖. If scanning is successful, then the data will be sent back. The scanner will stop automatically. If it is not
successful, the scanner will keep scanning, until the command of stop scanning is received.
【Exit Setup】
【Continuous Reading】
【Time Interval of Scanning】
【Extended Sense Reading】
【Set the Scanning Time Intervals】
23
Advertisement
Table of Contents
