Command Trigger Mode - Newland HR11+ Aringa User Manual

** Enter Setup

Command Trigger Mode

Command Trigger Mode: The scanner activates a decode session when receiving the command string
of "7E 01 30 30 30 30 40 53 43 4E 43 54 4D 31 3B 03" (~<SOH>0000@SCNCTM1;<ETX>) or scanning
the Start Trigger Simulation barcode. The decode session continues until the barcode is decoded, or
the decode session timeout expires, or the scanner receives the command string of "7E 01 30 30 30 30
40 53 43 4E 43 54 4D 30 3B 03" (~<SOH>0000@SCNCTM0;<ETX>) or scans the Stop Trigger
Simulation barcode.
If the scanner receives the command string of "7E 01 30 30 30 30 40 53 43 4E 43 54 4D 30 3B 03"
(~<SOH>0000@SCNCTM0;<ETX>) or scans the Stop Trigger Simulation barcode during a decode
session, it will stop the decode session right away.
Command Trigger Mode
Start Trigger Simulation Stop Trigger Simulation
Note: Command Trigger mode is available only when the scanner uses RS-232 or USB COM Port
Emulation. If you select this scan mode while using USB HID-KBW, USB HID-POS or IBM SurePOS
communication, the scanner will ignore this setting and automatically switch to the Blink mode.
Exit Setup 32