Table of Contents
Advertisement
**【Enter Setup】
Sense Mode
Sense Mode: The scanner activates a decode session every time when it detects a change in ambient illumination
(excluding the situation when change is detected before the timeout between decodes expires). Decode session continues
until the barcode is decoded or the decode session timeout expires.
Pressing the trigger can also activate a decode session. Holding down the trigger can suspend decode session. Same
barcode cannot be reread before the timeout between decodes (same barcode) expires.
【Sense Mode】
Decode Session Timeout: This parameter sets the maximum time decode session continues during a scan attempt. The
default timeout is 15s. To program this parameter, scan the Decode Session Timeout barcode and the numeric barcodes.
Timeout between Decodes: This parameter sets the time period between the end of one decode session and the start of
next session. It is programmable in 0.5s increments from 0s to 7.5s. The default timeout is 1s. To program this parameter,
scan the Timeout between Decodes barcode and the numeric barcodes.
Note: Decode Session Timeout: 01-15, corresponding to 1s, 2s,..., 15s (default), in 1s increments; 00: infinite.
Timeout between Decodes: 00-15, corresponding to 0s, 0.5s, 1s (default), ..., 7.5s, in 0.5s increments.
【Decode Session Timeout】
【Timeout between Decodes】
【Exit Setup】
27
Hide quick links:
Advertisement
Table of Contents
