Lane Assist System - Seat Alhambra Owner's Manual

Hide thumbs Also See for Alhambra:
Table of Contents

Advertisement

Factors that may affect how the radar
sensor operates
If laser sensor operation is impaired, due to
heavy rain, spray, snow or mud, the ACC is
deactivated temporarily. The relevant text
message will appear in the dash panel dis-
play. If necessary clean the SEAT
›››
badge
Fig.
263.
When the radar sensor begins to operate
properly again, the ACC will automatically
be available again. The message on the in-
strument panel screen will switch off and the
ACC will be reactivated again.
ACC operation may be affected by a strong
radar reverse reflection, for example in a
closed car park.
Trailer mode
When driving with trailer the ACC controls
less dynamically.
Overheated brakes
If the brakes overheat, for example after
abrupt braking or in long and steep slopes,
the ACC may be deactivated temporarily.
The relevant text message will appear in the
dash panel display. In this case, adaptive
cruise control cannot be activated.
Adaptive Cruise Control can be reactivated
once brake temperature has cooled suffi-
ciently. The message will disappear from the
286
Driving
instrument panel display. If the message ACC
remains on for quite a long
not available
time it means that there is a fault. Contact a
specialised workshop. SEAT recommends vis-
iting a SEAT dealership.

Lane Assist system*

Introduction
On the windscreen: field of vision of
Fig. 268
the camera of the Lane Assist system camera.
Using the camera located in the sun visor, the
lane assist system detects the possible lines
dividing it. When the vehicle involuntarily ap-
proaches a dividing line it has detected, the
system will notify the driver with a corrective
intervention. It is possible to over-regulate the
corrective intervention at any time.
If the turn signal is connected, there will be no
warning as the lane assist system under-
stands that you wish to change lanes volun-
tarily.
Control lamps
It lights up yellow
Lane assist system connected but inactive.
The system cannot detect the lane clearly. See
page 287, The lane assist system is inactive
(control lamp lit in
yellow).
It lights up green
Lane assist system connected and active.
Several warning and control lamps light up
for a few seconds when the ignition is switch-
ed on, signalling that the function is being
verified. They will switch off after a few sec-
onds.
WARNING
›››
Observe the safety warnings
trol and warning lamps on page
in Con-
109.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents