Navigation – Active Access Level Icons - Honeywell Touchpoint Plus Technical Handbook

 Sensor Catalogue 
 Module Data 
 SD Card
 Eject
 Format
 Power Off 
System Test
 Force Relay 
 Force 4–20 mA 
 Relay C & E Matrix 
 Dedicated Alarm Contacts 
7.4.1 Navigation – Active Access Level Icons
You must enter a valid password to access the menu items listed above. (See Ch.6.3 Logging In/Out.)
The silhouette icon shows who is logged in. Touch the icon to log in / out, or to change to a higher access level:
Note: The system will log you out after a set period of inactivity. (The default authentication timeout is 15 minutes, but this
can be changed in system settings.)
7.5 SD Card Usage
The SD card is used to store the system event history. Touchpoint Plus logs all events and all changes to input readings.
A notification will be given when the SD card has less than 50 Mb of space remaining. If the card is not replaced with an
empty one, or if space is not freed up, a further notification will be given when it is full and data is being overwritten. The
SD card icon also changes to yellow to indicate that there is a fault with data saving.
The Touchpoint Plus accepts standard size SD cards of 2 to 32 GB (FAT32). SD cards must be formatted on first
insertion.
7.5.1 Checking the Capacity of the SD Card
There are three ways to check the SD Card size and remaining space:
•
Touch Menu>Information>Additional Status.
•
Touch the SD Card icon in the menu toolbar (no icon = no SD Card, yellow icon = needs checking).
•
Touch the Power Supply icon in the menu toolbar.
MAN0984_Iss 3_02/16
Pt. No. 3011M5001_3
Operating Instructions
Menu Item
Table 14.
No one is logged in
Operator is logged in
Service engineer is logged in
Administrator is logged in
Admin. Service
 
 
 
 
 
 
 
 
 
 
 
User / Component Matrix
79
Operator Others
 
 
 
 
 
 
 
 
 
 
 
Technical Handbook
Touchpoint Plus