Chapter 4. System Mechanical Installation - Honeywell Touchpoint Plus Technical Handbook

Wall-mounted controller
Hide thumbs Also See for Touchpoint Plus:
Table of Contents

Advertisement

System Mechanical Installation

Chapter 4. System Mechanical Installation

The system can be directly wall-mounted or on an optional mounting fixture. Whichever method is chosen, the mounting
must be sound, secure, and capable of supporting the weight of the enclosure plus the weight of any cables and glands.
When choosing a location, it must be easily visible and accessible, with room to mount an external power isolator. There
must also be room to fully open the access door, which opens to the left, and room to easily access the door locking
handle and its securing screws, which are situated on the right. If using the optional expansion unit there must be
sufficient room between them to access the locking handle and its securing screws.
The units should be mounted so that the screen can be easily accessed and seen, but they should not obstruct accesses,
walkways or exits.
Although the units are IP65 when installed correctly, they should be mounted away from heat sources, out of direct
sunshine, and should be protected from rain, severe weather, steam or excess humidity and condensation.
These units have only passive cooling, so an adequate airflow must be maintained to prevent overheating.
Assembly
Wall mounted cabinet
It is the Customer's responsibility to ensure that the equipment is correctly installed, and that cable entry glands
Failure to do so will invalidate the quoted IP / NEMA / Pollution ratings and may invalidate the warranty.
The units as supplied have two hex-socket securing screws in the access door handle, and these have to be fully
unscrewed prior to opening the handle. Failing to do so could cause irreparable damage to the housing.
The handle must be correctly locked and the screws must be correctly tightened when the unit is in normal
operation. Failing to fully secure the enclosure is unsafe and will invalidate product certification.
MAN0984_Iss 3_02/16
Pt. No. 3011M5001_3
IP
NEMA
Pollution Degree
65
4X
CAUTION
or blanks of the appropriate IP rating are correctly used.
CAUTION
21
Remarks
When properly installed using the
2
appropriate cable entry glands
Touchpoint Plus
Technical Handbook

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tppl

Table of Contents