How To Change A Password - Honeywell Touchpoint Plus Technical Handbook

6.3.4 How To Change a Password

You can only change your own or lower level passwords. The initial default password for all levels is TPPL but it should
always be changed during or immediately after Commissioning.
1) Login as Service or Administrator.
2) Touch Menu icon>Configuration>Security>Password
3) Touch an access level icon and touch each box to open a keyboard.
Input the currently logged in password, the new password, and confirm the new password. (Toggle the [↓↑] key for
4)
upper / lower case letters, and the [?123] key for symbols.
5) Touch [Finish] to close the keyboard before touching the next box.
6) Touch [Change] when finished.
Note: The stored passwords will be replaced with the new passwords so you must also update any written copies.
For security reasons you must change the default Administrator, Service and Operator passwords at the earliest
At the very least you should keep a copy of the Administrator password in a safe place as it cannot be recovered
Careless password management can allow unauthorized access to the system, which may cause safety issues
that are the user's sole responsibility. Honeywell™ will not be liable if any end-user fails to follow established
6.3.5 Forgotten Passwords
The Administrator or Service Engineer can reset lower level passwords but the Administrator password cannot be
changed or reset without inputting the current Administrator password.
To reset a lower level password:
1) Log in as Administrator* or Service.
2) Go to
Menu>Configuration>Security>Password
3) Touch the user to change, then enter your own password, and then enter and confirm the new password.
4) Alternatively you can use the [Reset] button to reset to the default password TPPL, and then allow the user to set
their password as shown above.
* Lost Admin passwords can only be reset by authorised Honeywell Field Service Technicians. See the back page or
select
TPPL Menu>Information>Service Contact
MAN0984_Iss 3_02/16
Pt. No. 3011M5001_3
Commissioning
CAUTION
opportunity and periodically thereafter.
if lost or forgotten.
security protocols or the guidelines in this manual.
for details.
50
.
.
Touchpoint Plus
Technical Handbook