Safety Hazards, Warnings And Cautions
Conditions of Use
This Touchpoint Plus equipment shall only be operated:
•
By properly trained personnel.
•
Under Honeywell approved conditions.
•
With due authorisation.
•
Using approved maintenance and servicing procedures.
2.3.5 Training of Personnel
Honeywell and / or its distributors can provide training for operators and maintenance personnel. Personnel who have
been trained in operation and maintenance shall be limited to carrying out only those procedures and tasks taught during
the training course. Honeywell certified maintenance technicians must carry out all other tasks.
Honeywell can also provide additional or advanced training. Retraining is recommended periodically and whenever the
equipment / installation is changed or upgraded.
2.3.6 Conditions Satisfying Local, National and International Safety Regulations
Approved conditions must satisfy the requirements of applicable national and international safety standards and statutory
requirements relating to electrical, EMC, and health hazards. In addition, they must satisfy the requirements of the Site
Safety Officer and the local safety regulations.
2.3.7 Due Authorisation
Before any production, maintenance, or servicing procedure is carried out; written authorisation must be obtained from
one of the following personnel to confirm that the proposed task satisfies the necessary safety conditions:
•
A competent authorised person having a professional qualification in an appropriate technical discipline.
•
The Factory, Technical or Engineering Manager responsible for the working area.
•
The Site Safety Officer or an authorised Honeywell representative or approved distributor.
2.3.8 Approved Maintenance and Servicing Procedures
Approved Maintenance and Servicing Procedures are those stipulated in this manual or as authorised separately by
Honeywell.
It may be necessary to establish a temporary Locally Controlled Area (LCA) to restrict access during maintenance, testing
or servicing of this equipment.
MAN0984_Iss 3_02/16
Pt. No. 3011M5001_3
12
Touchpoint Plus
Technical Handbook