Touchpoint Plus Packaging - Honeywell Touchpoint Plus Technical Handbook

3.2.10 Touchpoint Plus Packaging

•
Touchpoint Plus outer packaging is made from cardboard. Facilities for recycling are widely available.
•
Touchpoint Plus inner packaging is made from Stratocell
recycled into new Stratocell
3.2.11 Packaging Components for Return to Manufacturer
Honeywell is unable to accept any consignment that does not conform to the European Classification, Labelling and
Packaging (CLP) Regulations (EC) 1272/2008.
Please consult your distributor, supplier, or the manufacturer if you require further advice.
3.2.12 Disposal (WEEE Directive)
The system contains Lithium batteries and a number of homogenous hazardous materials. These should be disposed of
carefully in accordance with the WEEE Directive and local laws and guidelines. Under no circumstances can they be
disposed of as domestic waste.
3.3 TPPL Construction
The TPPL system consists of a basic Control Unit and an optional Expansion Unit, as shown below.
3.3.1 TPPL Basic Control Unit
This figure shows the building blocks of the basic Touchpoint Plus system.
2
1
2
3
4
5
6
7
8
* The DIP Switch (14) is used to enable / disable the optional expansion box. See Ch.3.3.3 TPPL DIP Switches for further
information.
MAN0984_Iss 3_02/16
Pt. No. 3011M5001_3
System General Description
®
where such recycling facilities exist.
1
3 4
5
Figure 10. Controller Unit Layout Before Installation
Touchscreen PCB
SD Card
Motherboard
Modbus Terminals (option)
Ethernet Connector
Switched Mode Power Supply
DIP Switch (on backplane)*
Battery On / Off Switch
®
, Low-Density Polyethylene (LDPE) foam. The foam can be
6
15
9
Battery Connector
10 mA Output Modules
11
Relay Output Modules
12 Main Module
13
Input Module (mA/mV/Dual)
14 Backup Battery
15
Power Terminal
16 Earth (Ground) Bus Bar
18
8
7
9
10
11
12 13 14
16
Touchpoint Plus
Technical Handbook