Wall Mount Fixings - Honeywell Touchpoint Plus Technical Handbook

System Mechanical Installation

4.1.1 Wall Mount Fixings

You will require the following locally sourced items to install the Touchpoint Plus:
Tool to undo the enclosure access handle security screws:
•
3 mm Hex key
Suggested Fixings to screw the enclosure to the wall only:
•
Screw Max. Dia.:
•
Screw Min. Length:
•
Washer Max. Dia:
The sizes above are given to allow for clearance in the TPPL Enclosure. The actual length and type of fixing
Suggested Fixings for using the Mounting Plate:
For the plate, choose fixings appropriate to the surface and the weight of the enclosure plus cables. You will also need to
use suitable bolts, washers and lock nuts (see diagram below).
Ideally you will mount the enclosure and cables on a ≥20 mm ply board to allow cable troughs to be used.
Note:
You should ensure that washers between the TPPL enclosure and the wall or mounting plate are sufficiently large to
spread the load evenly.
•
For metal conduit, use a metal ground plate (e.g. use Honeywell Part No: TPPLOMGND).
•
For external visual/audio outlet, ensure IP65 is maintained (e.g. use Honeywell Part No: M-700123, available in the
Americas and AsiaPac only).
•
For cable glands, use type PG16 glands tightened to 5 Nm (44.2 lb-in) torque.
MAN0984_Iss 3_02/16
Pt. No. 3011M5001_3
6.4 mm (#14) dome or cheese head screw
76 mm (3 in.) – Normal fix
14.3 mm (0.56 in.)
should be determined by the surface material and the type of anchor required.
Enclosure Corner
Figure 16. Fixing Orientation When Using the Optional Mounting Plate
CAUTION
Wall or
Board
23
Touchpoint Plus
Technical Handbook