How To Update The Sensor Catalogue - Honeywell Touchpoint Plus Technical Handbook

Rectification and Modification

10.4 How to Update the Sensor Catalogue

From time to time, Honeywell will release new or updated versions of the sensor catalogue. It is not necessary to update
the catalogue every time, and it can wait until you want to install a type of sensor not previously listed.
The sensor catalogue should be updated before configuring new sensor types.
The TPPL has limited capacity to store events in its onboard memory so do not keep the Event logging SD Card
10.4.1 To Update the Sensor Catalogue
1) Download or copy the new sensor catalogue [TPP_CAT.bin] to a device having a Read/Write SD Card slot.
2) Put an empty 2 to 32 GB (FAT32) standard SD card into the SD device.
3) Create a new folder called CATALOG on the SD card and copy the downloaded sensor catalogue file into it.
4) Login as an Administrator or Service.
5) Touch
Menu>Maintenance> Power-off>Yes
6) Switch off and isolate the TPPL power supplies.
7) Open the TPPL enclosure door.
8) Temporarily replace the TPPL SD Card with the sensor catalogue SD card.
9) Close the enclosure door.
10) Switch power back on and wait for the system to stabilise.
11) Login as an Administrator.
12) Touch Menu>Maintenance>Update System>SensorCatalog
13) Touch [Update].
14) Wait for the sensor catalogue file to update, which may take several minutes.
15) Touch Menu>Maintenance> Power-off>Yes
16) Switch off and isolate the TPPL power supplies.
17) Open the TPPL enclosure door.
18) Replace the SD Card with the original SD card.
19) Close and secure the enclosure door.
20) Switch power back on and wait for the system to stabilise.
21) See and touch the SD Card icon to check the SD Card status.
MAN0984_Iss 3_02/16
Pt. No. 3011M5001_3
CAUTION
out any longer than necessary.
.
.
110
.
Technical Handbook
Touchpoint Plus