Route Subsystem; Table; Route Command Summary - Keithley 7002-HD User Manual

5-12 IEEE-488 Operation

ROUTe subsystem

The ROUTe subsystem is used to control signal routing through the switch system
and is summarized in

Table 5-3

ROUTe command summary

Command
[:ROUTe]
:CLOSe <list>
:STATe?
:CLOSe? <list>
:OPEN <list>|ALL
:OPEN? <list>
:SCAN <list>
:POINts?
:SCAN?
:FCHannels <list>
:FCHannels?
:INTerlockX
:LIST1
:LIST1?
:LIST2
:LIST2?
:CONFigure
:BBMake <b>
:BBMake?
:SCHannel <b>
:SCHannel?
:SLOTX
:STIMe <n>
:STIMe?
Table 5-3.
Close specified channels.
Query list of closed channels.
Query state of specified channels (1 = closed, 0 = open).
Open specified (or all) channels.
Query state of specified channels (1 = open, 0 = closed).
Define scan list.
Query number of channels in scan list.
Query scan list.
Specify channels that cannot be closed.
Query channels that cannot be closed.
Specify interlock (X = [1] to 5).
Define List 1 for specified interlock.
Query List 1 for specified interlock.
Define List 2 for specified interlock.
Query List 2 for specified interlock.
Configuration command path:
Enable (1 or ON) or Disable (0 or OFF)
Break-Before-Make switching.
Query Break-Before-Make.
ENable (1 or ON) or Disable (0 or OFF) Single Channel.
Query Single Channel.
Path to configure SLOT X (X = [1] to 10):
Specify delay (0 to 99999.999 seconds) for specified
slot.
Query delay for specified slot.
Return to
Section 5 topics
Model 7002-HD User's Manual
Description