Trigger Command Summary; Table - Keithley 7002-HD User Manual

Model 7002-HD User's Manual

Table 5-7

Trigger command summary

Command
:INITiate
[:IMMediate]
:CONTinuous <b>
:CONTinuous?
:ABORt
:ARM[:SEQuence[1]]
[:LAYer[1]]
:IMMediate
:COUNt <n>
:COUNt?
:SOURce <name>
:SOURce?
:SIGNal
:TCONfigure
:DIRection <name>
:DIRection?
:ASYNchronous
:ILINe <NRf>
:ILINe?
:OLINe <NRf>
:OLINe?
:LAYer2
:IMMediate
:COUNt <n>
:COUNt?
:DELay <n>
:DELay?
:SOURce <name>
:SOURce?
:TIMer <n>
:TIMer?
:SIGNal
Subsystem command path:
Initiate one trigger cycle.
Enable (1 or ON) or disable (0 or OFF) continuous initiation of
trigger system.
Query continuous initiation.
Reset trigger system.
Subsystem command path to configure arm layers:
Path to program arm layer 1:
Immediately go to Layer2.
Program arm count (1 to 9999, or INF).
Query arm count.
Select control source: HOLD, IMMediate, MANual, BUS,
TLINk.
Query control source.
Loop around control source.
Path to configure Triggers:
Enable (SOURce) or disable (ACCeptor) Bypass:
Query direction.
Path to configure asynchronous Trigger Link:
Select input line (1 to 6).
Query input line.
Select output line (1 to 6).
Query output line.
Path to program arm layer 2:
Immediately go to Trigger Layer.
Program scan count (1 to 9999 or INF).
Query scan count.
Program delay (0 to 99999.999 seconds).
Query delay.
Select control source: HOLD, IMMediate, TIMer,
MANual, BUS, TLINk.
Query control source.
Set timer interval (0 to 99999.999 seconds).
Query timer.
Loop around control source.
Return to
Section 5 topics
IEEE-488 Operation 5-17
Description