Primary Address Selection - Keithley 7002-HD User Manual

5-4 IEEE-488 Operation
Figure 5-3
IEEE-488 connector location

Primary address selection

The primary address may be set to any value between 0 and 30 as long as
address conflicts with other instruments are avoided. Note that controllers are also
given a primary address, so do not use that address either. Most frequently, con-
troller addresses are 0 or 21, but you should consult the controller's instruction
manual for details. Whatever primary address you choose, you must make certain
that it corresponds with the value specified as part of the controller's programming
language.
To check the present primary address or to change to a new one, perform the fol-
lowing procedure:
1.
2.
3.
4.
5.
TRIGGER LINK
IN OUT
MADE IN
U.S.A.
Display the MAIN MENU by pressing the MENU key.
Use the cursor keys to place the cursor on GPIB and press ENTER. The
GPIB SETUP MENU will then be displayed.
Use the cursor keys to place the cursor on ADDRESS and press ENTER.
The current primary address of the instrument will be displayed. For exam-
ple, if the instrument is set to primary address 7, the following message will
be displayed:
ADDRESS = 07 (0-30)
To retain the displayed address, press EXIT three times to return the instru-
ment to the channel status display state.
To change the primary address, use the keypad to display the new address
value (0 to 30) and press ENTER. Press EXIT two times to return to the
channel status display state.
Return to
IEEE-488 CARD 1
CARD 2
LINE RATING
100-240VAC
50, 60Hz
150VA MAX.
IEEE-488 Connector
Section 5 topics
Model 7002-HD User's Manual