2-2
Installation
Introduction
WARNING
This section includes information on installing cards in the Model 7002-HD High
Density Switch System.
Card installation and removal
The following paragraphs describe how to install and remove cards from the
Model 7002-HD mainframe.
WARNING
CAUTION
NOTE Make sure your external circuitry is wired to the card (as explained
in the card manual) before installing the card in the Model 7002-HD
mainframe.
The following information is intended for qualified service
personnel. Do not perform these procedures unless qualified
to do so.
To prevent electric shock that could result in serious injury or
death, adhere to following safety precautions:
• Before removing or installing a card in the Model 7002-HD
mainframe, make sure the mainframe power is turned off
and disconnected from line power.
• Before making or breaking connections, make sure power
is removed from all external circuitry.
Installation or removal of Model 7002-HD cards should be per-
formed by qualified service personnel only. Failure to recog-
nize and observe standard safety precautions could result in
personal injury or death.
To prevent performance degradation caused by contamination,
handle the card only by the edges and covers.
Return to
Section 2 topics
Model 7002-HD User's Manual