Bag F - Team Losi LOS-A0951 Owner's Manual

I''
BAG F
©
@
©
Fig 58.
0
0
Step 1. Inspect the inside of the tires [front (125), rear (126)] for any excess material. If present, trim excess rubber to ensure
proper seating of the tire on the wheel [front (127), rear (128)]. During tire assembly, make sure that all lettering faces
to the outside of the wheel (the side with the spokes).
*
Note: Do not set tires on furniture as they may leave permanent stains
Step 2. Pull the front tire (125} over the front wheel (127) and squeeze the tire (125) to properly seat it in the grooves of the
wheel (127}.
Step 3. Insert the foam tire liners (129) into the rear tires (126}. Pull the rear tire (126) over the rear wheel (128} and squeeze
the tire (126} to properly seat it in the grooves of the wheels (128). Make certain that the foam liners (129} are not
pinched between the tires (126) and the wheels (128}.
Step 4. The tires (125), (126) should now be glued to the wheels (127), (128}. This can be done by using a fast curing super
glue
™
or cyanoacrylate glue available at your hobby shop. Be sure to follow the manufacturers warnings on the
bottle.
&
IMPORTANT NOTE: Allow the glue to dry thoroughly before continuing.
Step 5. Attach the front wheel discs (130) to the outside of the front wheels (127}, and line up the holes in the disc (130} with
the holes in the wheel (127). Secure a front wheel disc (130) to each front wheel (127) with two 2-56 x 5/16" button
head screws (131).
Step 6. Press a 3/16" x 3/8" bearing (64} [3/16" x 3/8" plastic bushing (132} if building kit # A-0951] into each side of both front
wheels (127).
Step 7. Place a front axle spacer (133) over each front axle (15). Slide the front wheels (127) over the front axles (15} so the
wheel discs (130} face the outside. Secure the front wheels (127} by threading a 10-32 lock nut (134} onto the front
axle (15) and tightening.
&
IMPORTANT NOTE: Do not over tighten the front wheel nuts. The front tire should rotate freely.
Step 8. Insert the rear wheel discs (135) into the outside of the rear wheels (128}.
Step 9. Mount the rear wheels (128) to the rear axles (1 00} by lining up the pin (1 05) in the rear axle (1 00) with the groove in
the rear wheel (128) and pushing the wheel (128) all the way onto the axle (1 00}.
Step 10. Secure the rear wheels (128} by attaching 10-32 lock nuts (134} to the rear axles (1 00} and tightening.
&
IMPORTANT NOTE: Read and follow the manufacturers safety warnings regarding the use of the adhesives . DO NOT
spray glue accelerator on wheel discs!
~_"2)
(?
6
I
I
26