BAG C (Continued)
©
Fig 31.
Step 29 .. Insert a 3/16" x 3/8" bearing (64) [3/16" x 3/8"
bushing (65) if building kit# A-0951] into the top bearing seat
of the left gearbox half (66).
Step 30. Insert a 1/2" x 3/4" bearing (67) [1/2" x 3/4"
bushing (68) if building kit # A-0951] into the lower bearing
seat of the left gearbox half (66).
"------:::J
66
Figure 31
@
@
69
Fig 32.
Step 31. Insert a 3/16" x 3/8" bearing (64) into the top
bearing seat of the right gearbox half (69). Carefully push the
bearing (64) all the way into the bearing seat using a pen or
the handle of a hobby knife (with the blade removed). Care
70
should be taken not to damage the bearing shields.
Step 32. Press, and lightly tap the idler gear shaft (70),
into the hole in the center of the right gearbox half (69).
Step 33. Insert a 1/2" x 3/4" bearing (67) [1/2" x 3/4"
bushing (68) if building kit # A-0951] into the lower bearing
seat of the right gearbox half (69).
Step 34. Attach a 1 /8" 'E' clip (11) to one end of the
brake arm pin (71) and press the other end through the hole in
the right gearbox half (69) as shown. Push the pin (71) all the
way in so that the 'E' clip (11) is pushed against the inside of
the right gearbox half (69).
13
64
I
~
Figure 32