Table of Contents
Advertisement
BAG E (Continued)
@
Fig
52.
Step 6. Using needle nose pliers, or small vise grips,
grasp the front shock shaft (113} between the grooves and
thread a shock end (115) onto the shaft (113). Thread the
shock end (115) all the way onto the shaft (113).
Step 7. Repeat step 6 for the second front shaft (113)
and both rear shafts (114).
Step 8. Carefully snap a 1/4" swivel ball (116) into each
of the shock ends (115) on the four shock shafts (113), (114).
Fig
53.
@
Step 9. Snap a 1/8" 'E'-clip (11) into the groove closest
to the cartridge on both rear shock shafts (114).
Step 10. Before installing the 'E' -clip to the front shock
shafts (113), slide an 'A' shock spacer (117) (the smaller of the
two spacers, marked :4
J
over the shaft (113) next to the car-
tridge. Once the spacers are in place, snap a 1 /8" 'E' clip (11)
into the groove closest to the cartridge on both front shock
shafts (113).
*
Note: Shock spacers are only used on the front shock
shafts in this step.
Step 11 . Slide a shock piston (118) onto each of the four
shafts (113), (114) until it rests against the 'E'-clip (11). Se-
cure the pistons (118} to the four shafts (113), (114) with a
second 'E'-clip (11).
23
115
113
~
6Jtf
Figure 52
Figure 53
' '
'
'
'
Advertisement
Table of Contents
