BAGA
Dmmmmlmllllllllllllllllllllllllllllllm
CD
Figure 1.
Step 1. Insert a 4-40 x 3/4" cap head screw (1) through
the second hole in from the outside on each side of the front
shock tower (2). Thread a top shock mount bushing (3) onto
each of the two screws (1).
2
Step 2. Insert a 3/8" ball stud (4) into the inside of the
~
four camber holes on the bottom ofthe shock tower (2). Mount
the ball studs (4) from the same side of the shock tower (2) as
the screws (1) on both sides of the shock tower (2). Secure
the ball studs (4) with 4-40 lock nuts (5).
Dllllmllllllllllllllllllllllllllllllllilllllllllllllllll
Figure 2.
Step 3. Secure the front shock tower (2} to the front
bulkhead (6) with two 4-40 x 7/8" cap head screws (7} as shown.
The screws (7) should extend through the front of the bulk-
head (6). Be sure that the shock mount bushings (3) face the
correct direction as shown in figure 2.
7
1
5
Figure 1
6
Figure 2