Team Losi LOS-A0951 Owner's Manual page 32

Gtx pro kit with bushings & pull start engine/non pull start engine/no engine
Table of Contents

Advertisement

ENGINE INSTALLATION (Continued)
@
@
Dlllllllllllllllllllilmlilllllllllllllll
Fig 65.
@
Step 10. Slightly bend the throttle return spring eyelet
(149) as shown in figure 65. Place a studded ball washer {20}
over the four 4-40 x 5/8" cap head screws {152). Insert a 4-40
x 5/8" cap head screw (152) through the three holes in the
engine as illustrated. Place the bent throttle return spring eye-
let (149} over a fourth 4-40 x 5/8" cap head screw {152) and
insert it through the fourth hole in the engine as shown.
Step 11 . Place an engine mount spacer (150} over each
ofthe four screws {152). Attach the engine to the engine mounts
(151) by threading the four screws (152) into the four holes
shown. Do not fully tighten the screws yet.
*NOTE: The two engine mounts should be positioned
differently on each side of the motor as shown in figure 65.
.&
IMPORTANT NOTE: Make sure that the engine
mounts are installed correctly as indicated in figure 65. The
four screws should be threaded into the holes which do not
pass all the way through the engine mounts.
@
0111111111111111111111111111111111
D
@
0
@
Fig 66.
Step 10. Slightly bend the throttle return spring eyelet
(149) as shown in figure 66. Place a studded ball washer (20)
over the four 4-40 x 1/2" cap head screws (124). Insert a 4-40
x 1 /2" cap head screw (124) through the three holes in the
engine as illustrated. Place the bent throttle return spring eye-
let (149} over a fourth 4-40 x 1 /2" cap head screw {124) and
insert it through the fourth hole in the engine as shown.
Step 11. Attach the engine to the engine mounts (151)
by threading the four screws {124) into the four holes shown.
Do not fully tighten the screws yet.
*NOTE: The two engine mounts should be positioned
differently on each side of the motor as shown in figure 65.
.&
IMPORTANT NOTE: Make sure that the engine
mounts are installed correctly as indicated in figure 66. The
four screws- should be threaded into the holes which do not
pass all the way through the engine mounts.
15
Figure 65
Figure 66
29
'
I
'
I
-,_
'
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
'
I
I
I
I
I
I
em
I
I
I
1
I
I
I
i
6----0
a .
I
I
~~
~
151

Advertisement

Table of Contents
loading

This manual is also suitable for:

Los-a0953Los-a0952Los-a0954

Table of Contents