Table of Contents
Advertisement
I
RADIO INSTALLATION (Continued)
111111111111111111111111111111111
8]111111111111111111111111111111111
0
Fig 85.
Step 19. Thread a short plastic rod end (171) onto each
end of a 1-1/8" turnbuckle (187). Tighten both ends equally
until the rod is the same length as the one shown in figure
85A.
Fig 86.
Step 20. Attach one end of the rod from figure 85 to the
ball stud (21) in the steering servo horn. Attach the other end
of the rod to the ball stud (4) in the steering bellcrank (32).
Fig 87.
Step 21. Cut a piece of two sided tape (172) to the same
size as the bottom of the receiver. Remove the backing from
one side of the tape (172) and attach the tape (172) to the
bottom of the receiver.
~
For best results clean the surfaces that the two
sided tape will be attached to with a mild rubbing alcohol.
Thi~
will ensure a good, strong bond. Allow the surface to fully dry
before attaching the tape.
Step 22. Remove the backing from the remaining side of
the two sided tape (172) and attach the receiver to the top of
the center chassis brace (37), just to the right of center, as
shown. The receiver should be mounted to an area where there
is as much material under it as possible. Try not to mount it
directly over an opening in the center chassis brace (37).
Step 23. Plug the steering servo into the slot marked
"c_hanhel 1" on the receiver.
~
QjJ
~--~--aJ
Figure 85
Figure 85A
Figure 86
37
Figure 87
38
I 7 2
Advertisement
Table of Contents
