Team Losi LOS-A0951 Owner's Manual page 33

II
li
I
I;:
ENGINE INSTALLATION (Continued)
Fig 67.
Step 12. Install the carburetor to the engine as per the
instructions supplied with the engine. The carburetor throttle
arm should be on the same side as the throttle return spring
eyelet (149).
Step 13. Attach one end of the throttle return spring (153)
to the return spring eyelet (149). Attach the opposite end of
the spring (153) to the lower hole (center hole if your carbure-
tor has three hcles) in the carburetor throttle arm.
Fig 68.
Step 14. Press the paper air filter element (154) into the
large end ofthe air filter boot (i 55). Be sure that the side of the
paper element (154) with the hole in it is inserted into the boot
(155).
Step 15. Slide the foam pre-filter (156) over the paper
filter (154).
:>-o Air filter oil can be applied to the foam pre filter if
you plan to run in a dusty area. Filter oil can be purchased at
any motorcycle shop. Do not apply filter oil to the paper
filter element.
Step 16. Attach the air filter boot (155) to the carburetor.
Secure the boot (155) to the carburetor with a 4" tie-strap (157).
Tighten the tie strap (157) and cut any excess material off of
the tie-strap (157).
*NOTE: The locking portion of the tie strap should be
positioned away from the fuel fitting on the carburetor. This will
keep the tie strap from interfering with the fuel line.
Figure 67
Figure 68
30