Table of Contents
Advertisement
ENGINE INSTALLATION (Continued)
Fig
73.
Step 29. Slide the pipe mounting bracket (162) over the
tuned pipe (161) as shown. The mounting bracket (162) should
be positioned against the front side of the seam on the pipe
(161).
*NOTE: If the bracket does not fit snugly around the pipe,
the bracket can be bent slightly so that it will hold the pipe
tighter.
Step 30. Place a #4 washer (39) over a 4-40 x 3/8" cap
head screw (14). Thread the screw (14) through the pipe
mounting bracket (162), into the hole in the top of the center
chassis brace (37), and tighten.
0
Fig
74.
Step 31 . Cut a 1-1/2"1ength of3/8" silicone tubing (164).
The edges should be cut as straight as possible. This piece of
tubing will be used as the tuned pipe stinger.
Step 32. Insert the aluminum stinger sleeve (165) into
one end of the rubber stinger. The sleeve (165) should be in-
serted 1 /16" inside the edge of the stinger.
Step 33. Moisten the outside edge of the stinger on the
side that the sleeve (165) is inserted. Press the exhaust stinger
into the large hole in the tuned pipe (161) so that the sleeve
(165) is centered in the wall of the pipe (161) see figure 74A.
14
Figure 73
Figure 74
Figure 74A
33
Advertisement
Table of Contents
