Table of Contents
Advertisement
I'
I
i
BAG B (Continued)
lllllll!llllllllllllllllmllll
[§
1111111111111111111111mmllll
Figure
12.
Step 7. Thread a plastic rod end (24) onto each end of a
1-7/8" turnbuckle (25). Tighten both rod ends equally until the
rod is the same length as the rod shown in figure 12A. Make
two of the tie-rod assemblies.
Figure
13.
Step 8. Attach one end of a tie-rod assembly to the ball
stud (21) on the right side of the sector arm (33) and the other
end to the ball stud (21) on the right spindle (16).
Step 9. Repeat step 8 for the left side.
~
Mount all of the camber rods so that the adjust-
ment hex is to the outside of the truck. This will make future
adjustments much easier.
©
Figure 14.
Step 10. Press a rubber tank mounting grommet (36)
into each of the three large holes in the top of the center chas-
sis brace (37) as shown. The grommets (36) should be cen-
tered, top to bottom, in the holes of the chassis brace (37).
Figure 12
Figure 12A
Figure 13
Figure 14
6
Advertisement
Table of Contents
