Team Losi LOS-A0951 Owner's Manual page 43

1
1
1il
1' 1 !
''
RADIO INSTALLATION (Continued)
•
Fig 90.
Step 33. Bend the short 'Z' bend wire (175) as shown in
figure 90A. Install the short 'Z' bend wire (175) in the top hole
of the carburetor throttle arm so that the wire is positioned on
the side of the arm away from the engine.
Step 34. Slide the end of the wire (175) through the hole
in the throttle pivot (169).
Step 35. Once the wire (175) is through the pivot (169),
place a linkage adjustment collar (176) over the end of the
wire (175). Secure the collar (176) to the wire (175) with a 4-40
set screw (177). The collar (176) should be positioned at the
end of the wire (175). Final adjustments will be made later.
@] •
Fig 91.
Figure 90
Step 36. Install the long 'Z' bend wire (178) in the outside hole of the throttle servo horn (168) so that the wire is positioned
on the top side of the servo horn (168).
Step 37. Slide a linkage adjustment collar (176) over the end of the wire (178) and secure it with a 4-40 set screw (177)
1-1 /2" from the end of the wire (178).
Step 38. Slide the end of the wire (178) through the hole in the brake arm (79).
Step 39. Rotate the brake arm (79) forward so that it rests against the brake drum (82). Slide a linkage spring (179) over the
end of the wire (178) and position it against the brake arm (79). Place another linkage adjustment collar (176) over the end ofthe
wire (178) and secure it with a 4-40 set screw (177) near the end of the wire (178) . Once again, final linkage adjustment will be
made later.
I 76
Figure 91
40