Team Losi LOS-A0951 Owner's Manual page 5

I!
BAG A (Continued)
rn~------------~~
Figure 3.
Step 4. Attach the front suspension arms [left (8), right
(9)] to the front bulkhead (6} by sliding a 1 /8" inner front hinge
pin (1 0) through the arm (8), (9) and bulkhead (6). Center the
hinge pin (10) and secure it with two 1/8"'E' clips (11) .
.&
IMPORTANT NOTE: Be
~ure
that the arms sweep
to the rear and the shock mounting area is facing up.
Figure 4.
Step 5. Attach the front body mount slide (12} to the
front side of the front body mount support (13} by threading
two 4-40 x 3/8" cap head screws (14} into the top hole in the
body mount slide (12} (this hole does not go all the way
through), through the holes in the body mou.nt support (13) as
shown.
Step 6. Place the body mount support (13) over the two
screws (7) protruding from the front of the bulkhead (6) so that
the body mount support (13) angles forward. Secure the body
mount assembly with two 4-40 lock nuts (5).
*NOTE: Assure that the body mount slide (12) angles
down, to111ards the front.
Figure 3
Figure 4
2