Team Losi LOS-A0951 Owner's Manual page 6

BAG A (Continued)
oo-u
rn
liD
•
Figure 5.
0
@ @
Step 7. Slide a front axle (15) into the right spindle (16)
so that the hole in the axle (15) lines up with the hole in the
spindle (16).
*NOTE: Spindles are marked with 'L' and 'R' to designate
left and right.
Step 8. Place the assembled spindle (16) and axle (15)
in the right spindle carrier (17) so that the letter on the spindle
(16) faces up. Insert a 1 /8" x .960" hinge pin (18) through the
spindle carrier (17), spindle (16), and axle (15). Center the
hinge pin (18) in the assembly and secure it with two 1 /8" 'E'
clips (11).
Step 9. Ensure that the hinge pin (18) is centered in the
spindle carrier (17) and thread a 5-40 set screw (19) into the
rear of the front axle (15). Tighten the set screw against the
hinge pin (18) until snug.
Step 1 0. Place a studded ball washer (20) over a 3/8"
ball stud (4) and thread the ball stud into the top hole of the
spindle carrier (17), as shown, until snug. Thread a 3/16" ball
stud (21) into the spindle from the top until snug.
Lt_
IMPORTANT NOTE: Refer to the illustration and
be certain that the spindle carrier and spindle are assembled
correctly and the reference letters face the correct direction.
Step 11. Repeat steps 7-1 0 for the left side parts [left
spindle (22), left spindle carrier (23)].
rnc__ __
_____j~
@
Figure 6.
Step 12. Attach the right spindle carrier assembly to the
right suspension arm (9) by sliding a 1/8" x .960" hinge pin
(18) through the arm (9) and spindle carrier (17). Center the
hinge pin (18) in the arm (9) and secure it with two 1 /8" 'E' clips
(11).
Lt_
IMPORTANT NOTE: Make sure that the letter on
the spindle faces up.
Step 13. Repeat step 12 for left side.
@
~
@
@
21
15
Figure 5
Figure 6
3
20