Table of Contents
Advertisement
l!
I'
BAG E
@
Fig
50.
Step 1 . Place one shock '0' ring (1 08) into the cartridge
body (1 09), making sure that the '0' ring (1 08) sits flat on the
bottom of the cartridge body (1 09).
Step 2. Insert the cartridge spacer (11
0)
into the car-
tridge body (1 09) followed by a second '0' ring (1 08).
Step 3. Once the second '0' ring (1 08) is inserted, and
is flush with the top of the cartridge body (1 09), "snap" the
cartridge cap (111) onto the cartridge body (1 09).
Step 4. Make four cartridge assemblies.
*
Note: Cartridges in some kits may be pre-assembled
at the factory.
108
109
[]~--------------~UI00-~~~001
[ ] _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
~11-lilllll~illlil
@
Fig
51.
Step 5. Place a drop of shock fluid (112) on the grooved
end of each shock shaft [front (113), rear (114)] and slide a
cartridge, hex end first, down the shock shaft (113), (.114) to-
ward the threads.
22
Figure 50
il
Figure 51
I
I
I
I
I
I I I
I 10
Advertisement
Table of Contents
