Table of Contents
Advertisement
Step 14. Press a 3/16" x 3/8" bearing (64) [3/16" x 3/8"
bushing (65) if building kit# A-0951] into each side of a rear
hub (1 03).
Step 15. Place a studded ball washer (20) over a 3/8"
ball stud (4). Thread the ball stud (4) into the #4 hole (shown
in figure 46A) in the rear hub (1 03). Place a "foam thing" (26)
over the ball stud (4).
Step 16. Repeat steps 14-15 for the other side .
.&
IMPORTANT NOTE: Make sure that the ball studs
are attached to opposite sides of the rear hubs so that when
the hubs are installed the ball studs will face the same direc-
tion.
Step 17. Slide a rear axle (1 00) through the bearings
(64) [or bushings (65)] in each rear hub (1 03) from the inside
as shown.
Step 18. Place a rear axle spacer (1 04) over each rear
axle (1 00), against the outside bearing (64) [or bushing (65)].
Step 19. Secure the rear axle (1 00) and spacer (1 04) by
pressing a 1/16" x 7/16" pin (105) through the small hole in
each of the rear axles (1 00). The pin (1 05) should be centered
in the rear axle (1 00).
mc__ ____
___j~
@
Fig 47.
Ste~
20. Slide an outer rear hinge pin (1 06) partially
through the outside of the right rear suspension arm (93) from
the rear. Slide a rear hub spacer (1 07) over the pin (1 06) and
against the rear portion of the suspension arm (93).
Step 21. Place the right rear hub (1 03) (ball stud (4)
facing rearward) between the outer rails of the suspension arm
(93), against the rear hub spacer (1 07). Slide the hinge pin
(1 06) partially through the hub (1 03).
Step 22. Insert another rear hub spacer (1 07) between
the rear hub (1 03) and the forward rail of the suspension arm
(93). Slide the hinge pin (1 06) through both sides of the sus-
pension arm (93), the rear hub (1 03), and both rear hub spac-
ers (107). Secure the hinge pin with two 1/8" 'E'-clips (11).
_Step 23. Repeat steps 20-22 for the left suspension arm
(94) and left hub (1 03).
103
Figure 46
Figure 47
20
Advertisement
Table of Contents
