Table of Contents
Advertisement
BAG C (Continued)
0
©
0
Figure
23.
Step 7. Insert a 5mm x 8mm bearing (50) [5mm x 8mm
bushing (51) if assembling kit# A-0951] into the center of the
diff gear (52).
Step 8. Press a 3/32" diff ball (53) into each of the small
holes in the diff gear (52).
Fig 24.
Step 9. Apply a fairly heavy coat of diff grease (48) to
the exposed side of the diffwasher (49) that is already attached
to the outdrive (47).
Step 1 0. Carefully place the diff gear (52) over the diff
tube (46) so that the diff balls (53) and diff gear (52) rest against
the greased diff washer (49) .
.&
IMPORTANT NOTE: It is a good idea to hold the
diff nut carrier in place so that the diff tube is not moved when
the gear is pushed over it.
0
©
0
Fig
25.
Step 11. Insert a 5mm x 8mm bearing (50) [5mm x 8mm"
bushing (51) if assembling kit# A-0951] into the second
outdrive/diff half (47). Make sure thatthe bearing (50) [or bush-
ing (51)] is pushed all the way into the outdrive (47). The handle
of a hobby knife (with the blade removed) or a pencil can be
used to push the bearing (50) [or bushing (51)] into place.
Step 12. Drop the 1 /4" x 5/16" shim (54) into the outdrive
(47), on top of the 5mm x 8mm bearing (50) [or bushing (51)].
Make sure that the shim (54) sits flat against the bearing (50)
[or bushing (51)].
*NOTE: Be extra careful not to bend this shim!
10
~
\
c/?bQ
cc;,
: : : :
I
l1
I
I
I I
I
I
l1
I
I
II
I
'
'
'
IJJ
'I
I
,,
Figure 23
APPLY GREASE
TO WASHER
52
Figure 24
53
Figure 25
53
49
Advertisement
Table of Contents
