Team Losi LOS-A0951 Owner's Manual page 44

RADIO INSTALLATION (Continued)
Fig 92.
Step 40. Remove the backing from the receiver battery
pad (180) and attach it to the back of the chassis (27) so that it
matches the shape of the chassis (27).
Fig 93.
Step 41 . Place the receiver battery in the rear portion of
the chassis (27), on top of the pad (180), so that the lead wire
is to the left side of the chassis (27).
&
IMPORTANT NOTE: If using the plastic battery
holder (supplied with the radio system), wrap tape around the
holder after the batteries are installed. This will help hold the
batteries in place. The plastic battery holder should be mounted
to the chassis so that the plastic sides are to the top and bot-
tom.
Step 42. Insert an 8" tie strap (181), from the outside,
through the forward hole in the right side of the chassis (27).
Run the tie strap (181) over the battery and through the rear
hole in the left side of the chassis (27).
Step 43. Insert a second 8" tie strap (181 ), from the out-
side, through the rear hole in the right side of the chassis (27).
Run the tie strap (181) over the battery and through the for-
ward hole in the left side of the chassis (27).
Step 44. Cut the square, locking portion off of two more
8" tie straps (181). Secure the two installed tie straps (181)
with the locking portions of the tie straps that were just cut off.
Pull the tie straps tight and cut off any excess.
180
27
Figure 92
27
Figure 93
41