Table of Contents
Advertisement
BAG C (Continued)
@
@
Fig 26.
Step 13. Locate the diff adjusting screw (55) and place
the foam thrust bearing seal (56) over the shoulder of the screw
(55).
Step 14. Place one of the 3mm x 8mm raced thrust bear-
ing washers (57) over the diff screw (55) so that the groove
faces up.
Step 15. Grease the thrust washer (57) well and place
the 3rnm x 8mm thrust bearing (58) over the screw (55) and
next to the washer (57). Grease the exposed side of the thrust
bearing (58) well and place the second thrust washer (57) over
the screw and against the thrust bearing (58). This time the
groove in the thrust washer (57) faces down.
Step 16. Very carefully insert the diff screw (55), with the
thrust bearing assembly installed, into the outdrive (47). Be
very careful not to bend or pinch the shim (54) while inserting
the diff screw (55). Pull the threaded end of the diff screw (55)
until the thrust bearing assembly rests against the shim (54),
next to the bearing (50) [or bushing (51)], inside the outdrive
(47).
Fig 27.
Step 17. Locate the smallest of the allen wrenches (44)
and place it in the slot in the outdrive (47) containing the diff
screw (55). Slide the wrench all the way down against the
screw (55). By handling the outdrive (47) with the wrench
inserted, the diff screw (55) will be held in place while finishing
assembly of the diff.
Step 18. Apply a small amount of grease (48) to the
outer ring of the outdrive (47). Install the second diff washer
(49), again lining up the slots in the outdrive (47) and the washer
(49).
Step 19. Apply a fairly heavy coat of diff grease (48) to
the exposed side of the diff washer (49).
47
GREASE
Figure 26
4 9
Figure 27
11
SMALL AMOUNT
OF GREASE
44
Advertisement
Table of Contents
